Technical Drawing Guidelines for Tape Dispenser Views

Draw Guidelines Draw three horizontal rectangles for Top View, Front View, and Right Side View (RHS). Arrange them like this: Front View: Centered in the middle. Top View: Directly above the Front View. RHS View: To the right of the Front View. --- Step 3: Draw Each View Front View (Length: 15 cm, Height: 7 cm) 1. Draw a rectangle 15 cm wide and 7 cm tall. 2. Add: The curved slot for the tape roll. The tape cutting edge near the bottom right corner. 3. Use construction lines for symmetry. Top View (Length: 15 cm, Width: 10 cm) 1. Draw a rectangle 15 cm x 10 cm. 2. Add: The slot outline in the center for the tape roll. The front slope of the dispenser. RHS View (Height: 7 cm, Width: 10 cm) 1. Draw a rectangle 7 cm tall and 10 cm wide. 2. Include: The side profile of the tape roll slot. The slope of the dispenser. --- Step 4: Label and Dimension Label each view as: FRONT VIEW TOP VIEW RHS VIEW Add dimensions: Length (15 cm) in the Front and Top Views. Width (10 cm) in the Top and RHS Views. Height (7 cm) in the Front and RHS Views, Draw three horizontal rectangles for Top View, Front View, and Right Side View. Arrange them. Front View is centered in the middle. Top View is directly above the Front View. RHS View is to the right of the Front View